Made-to-measure cabinets, in 3D
FlowCraft works out panels, joints, edge banding, fillers and plinth to the millimetre, with the materials from your catalogue.
From your own drawing
01
The designer sets up the cabinet in SketchUp.
02
FlowCraft works out the panels, joints and edges, with the materials from the catalogue.
03
The panel list, DXF files for the machines and a photorealistic image for the client follow from it.
01
The request comes in
A sketch on paper, a photo or a few sentences from the client meeting.
Example with fictitious data
Make this cabinet: 120 wide, 180 high, 45 deep. All compartments closed, each door in the colour of its compartment.
cabinet-sketch.jpg
02
The Mind turns it into a cabinet
The Mind turns the request into a cabinet: outer size, division, fronts, material and edges.
Example with fictitious data
- Outer size
- 1200 × 1800 × 450 mm
- Division
- A narrow column on the left with three compartments, on the right one large compartment with three smaller ones below
- Fronts
- Seven doors, three hinged on the left and four on the right
- Panels
- 18 mm, back 8 mm
03
FlowCraft builds the cabinet
The 3D model follows, with every joint and edge.
Real FlowCraft output
04
Panel list and production
Cutting sizes per panel, the DXF for the machines and the quotation follow from the model. Nothing goes to production without a staff member's approval.
Real FlowCraft output
| Type | Count | Sizes |
|---|---|---|
| Side panels | 2 | 1764 × 422 × 18 · 1764 × 422 × 18 |
| Top and bottom panels | 5 | 867 × 422 × 18 · 595 × 422 × 18 · 422 × 315 × 18 · 422 × 315 × 18 · 422 × 254 × 18 |
| Dividers and shelves | 6 | 1800 × 422 × 18 · 849 × 422 × 18 · 747 × 450 × 18 · 422 × 297 × 18 · 422 × 297 × 18 · 422 × 236 × 18 |
| Back panels | 2 | 1800 × 885 × 8 · 1800 × 333 × 8 |
| Doors | 7 | 1017 × 849 × 18 · 774 × 297 × 18 · 729 × 595 × 18 · 657 × 297 × 18 · 360 × 236 × 18 · 351 × 236 × 18 · 297 × 297 × 18 |
Two cabinets, fully worked out
A Mondrian-style design cabinet with 22 panels and a bedroom wall unit with 58 panels, fillers and plinth.
The 3D model and panel list are real FlowCraft output. The sketch and the conversation in the films are examples. The films are in Dutch.
A one-time setup, then usage in credits
The setup builds the product on your own rules and documents. After that you pay only for what you actually use.